Skip to content

PROTECTION FROM THE FIRST DESIGN STEP

Your garden. Safe water.

Backflow prevention, BA devices and air gaps – essential considerations for irrigation.

PROTECT DRINKING WATER · PLAN RESPONSIBLY

Clean water.
Proper separation.

Water used by an irrigation system must not flow back into the household drinking-water installation. Drinking-water protection should therefore be considered at the planning stage.

Schematic illustration comparing BA backflow protection and an air gap; not an installation drawing
AI illustration · simplified explanatory concept · final selection only after a professional risk assessment
01

Prevent backflow

Pressure changes may cause irrigation water to flow back into the drinking-water supply. Suitable protection is needed to prevent contamination.

02

Assess the risk category

The correct protective device depends on the actual connection and fluid risk category – not just the size of the garden.

03

Coordinate with specialists

Any connection to the drinking-water installation should be designed and carried out with an appropriately qualified plumbing professional.

BA backflow preventer or air gap?

Simplified concept · not installation instructions

UP TO FLUID CATEGORY 4

Type BA system separator

A BA device with a controllable reduced-pressure zone can suit applications classified up to category 4. It does not protect against category 5 risks.

ALSO FOR FLUID CATEGORY 5

Type AA / AB air gap

Below-ground sprinklers and drip lines may fall under category 5. In these cases physical separation, for example a break tank with a suitable air gap, is generally required.

The appropriate protection must be assessed for each actual installation under the applicable technical rules. This simplified illustration does not replace professional design.

SOURCE & SUPPLY

Protection starts at the source.

Whether your garden uses mains water, a well, a pump or a rainwater tank, the system should be planned around both reliable supply and safe separation – especially where potable water is used for top-ups.

Discuss water safety for your projectExplore irrigation technology

Technical references: DIN EN 1717:2026-08, DIN 1988-100 and the BDEW guide to garden-water connections (2021).

PERSONAL ADVICE

Your project deserves the very best.

We consider the water supply and drinking-water protection right from the start.

Start a conversation
WhatsApp